Degree Of Water Hardness - Hanseatic HGTI4582E97736BS User Manual

Page EN-34 Installation, assembly, connection and initial commissioning

Degree of water hardness

Hard water will cause calcification within the
dishwasher. Also, more dishwasher deter-
gent will be required to clean the dishes. Soft
water increases foaming.
For this reason, the degree of hardness of
the water has to be determined and adjusted
even before the first use. You can determine
the water hardness from your water bill or
enquire about the degree of hardness at the
water supply company. The appliance is fac-
tory-set to a hardness level of "H3".
Adjusting the water hardness level
(12)
(13)
1. Close the dishwasher door.
2. If the dishwasher is switched on, switch it
off.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
2. Press and hold the P button (9) until LEDs
(12) and (13) flash alternately.
(9)
3. Press the P button (9) repeatedly until
4. Around 5 seconds after you push it for the
Please refer to the following table for the
relevant water hardness setting:
°dH LED display
0-5
6-11
12-17
18-22
23-34
35-55
the required hardness level is displayed.
last time, the dishwasher will automatical-
ly revert to the normal display. The hard-
ness level setting is saved.
Setting
H1
H2
H3
H4
H5
H6