Kenwood NX-5200K3 User Manual page 69

Model
Serial
Hardware Ver. : The hardware version of a registered Bluetooth-enabled
Firmware Ver. : The firmware version of a registered Bluetooth-enabled
Software Ver.
Device Class
Audio/Video
Phone
Computer
LAN/Network
Peripheral
Imaging
Wearable
Toy
Health
Note:
You can also check the information of the devices in the Find Device mode.
●
The icons listed in the above table indicate the connection status of the Headset Profile,
●
Heart Rate Service and Automatic Injury Detection Service. They are not applicable to the
Serial Port Profile connection.
Switching the speaker audio output
o
You can switch the audio output between the speaker of the transceiver and the
Bluetooth headset.
Press the key programmed as [Bluetooth Speaker] to change the setting ("Off" or
"Only").
Alternatively, press the key programmed as [Menu] to enter Bluetooth Speaker Mode
using the Menu Mode. Press the [J] and [K] keys to select "Off" or "Only".
Off : Audio is output from the built-in speaker of the transceiver.
Only : Audio is output from the speaker of the Bluetooth device.
Press the [ ] or [ ] key to confirm your selection.
: The model number of a registered Bluetooth-enabled device
that supports Device Information Service.
: The serial number of a registered Bluetooth-enabled device
that supports Device Information Service.
device that supports Device Information Service.
device that supports Device Information Service.
: The software version of a registered Bluetooth-enabled
device that supports Device Information Service.
Disconnected Connected
69