Kenwood NX-5200K3 User Manual page 30

Key Lock <KeyLck>
o
Press this key to lock the transceiver keys. Press the key again to unlock the keys.
The Selector, Lever switch as well as the PTT key on an external microphone or a
Bluetooth device still function normally, and the following functions can still be
operated: Backlight, Battery Status, Call Response, Clear, Emergency, Function,
Key Lock, LCD Brightness, Monitor, Monitor Momentary, Squelch Off, Squelch Off
Momentary and Zeroize.
Keyset <Keyset>
o
Allows you to change the active Keyset stored in a Secure Cryptographic Module
(SCM).
Language
o
Allows you to change the language of the text display on the LCD screen and the
language of the voice announcement. Refer to "MULTI LANGUAGE" {p. 52} .
LCD Brightness <Bright>
o
Allows you to adjust the brightness of the LCD backlight depending on the
surrounding lighting conditions.
Lone Worker <LoneWk>
o
Enables or disables Lone Worker function.
Low Transmit Power <Low>
o
Turns Low Transmit Power on or off. When using a channel programmed with
medium or high power, this allows you to change the output power to low.
Maintenance <Maint>
o
Allows you to display the signal strength, site information and Bit Error Rate (BER)
on the LCD when constructing the system or during maintenance.
Manual Site Hunt <M.Hunt>
o
Enables or disables Manual Site Hunt function. Applicable to DMR Site Roaming
only.
Medium Transmit Power
o
Turns Medium Transmit Power on or off. When using a channel programmed with
low or high power, this allows you to change the output power to medium.
Menu <Menu>
o
Press this key to select and perform functions using the transceiver Menu.
Mic Sense
o
Allows you to change the microphone sensitivity.
Microphone Type
o
Allows you to select a microphone type that suits the optional external microphone
connected.
30