Kenwood NX-5200K3 User Manual page 27

Call 1 ~ 6 <Call1 ~ Call6>
o
Press this key to send a message or initiate a call.
Call Interruption <Intrpt>
o
Allows a transceiver other than the transmitting transceiver to terminate voice
communications by sending and receiving a Call Interruption request message. If a
transceiver receives a Call Interruption request message on the channel where the
transceiver is performing voice communications, the transceiver terminates the voice
communications.
Call Response <CalRes>
o
Press this key to respond to an Individual Call. When an Individual Call is received,
the Alert tone stops.
Channel Down <CH->
o
Press this key to decrease the channel number. {p. 4}
Channel Entry <CH_Ent>
o
Press this key to enter Channel Entry Mode, to select a channel.
Channel Information <ChInfo>
o
Allows you to cycle through the display information as follows: Channel name > Zone-
channel number > Frequency > QT/DQT > RAN
Channel Recall <CH_Rcl>
o
Press this key during Scan to return to the last called zone and channel.
Channel Select
o
Turn the Selector knob clockwise to increase the channel number and
counterclockwise to decrease it.
Channel Up <CH+>
o
Press this key to increase the channel number. {p. 4}
Clear <Clear>
o
Press this key to end a call or cancel a data transmission.
Clock <Clock>
o
Refer to "CLOCK" {p. 48} .
Clock Adjustment <ClkAdj>
o
Allows you to set the clock. Refer to "CLOCK" {p. 48} .
Color Scheme
o
Allows you to change the color scheme of the LCD. Refer to "COLOR
SCHEME" {p. 49} .
27