Kenwood NX-5200K3 User Manual page 39

Priority Channel Editing
o
If the Priority channel (Priority 1/ Priority 2) has been set as Operator Selectable by
your dealer, you can reprogram the Priority channels.
Note:
A zone/ channel must be added to the scan list before the channel can be set as a Priority
●
channel.
The Priority channel cannot be reprogrammed on the NXDN Trunking scan list and when
●
Scan Type has been set to "Limited Talkgroup".
1
Select the channel where the scan list to be edited has been set, press the key
programmed as [Scan Program] to enter Scan Program Mode.
Alternatively, press the key programmed as [Menu] to enter Scan Program Mode using
the Menu Mode.
2
Press the [ ] key to edit the Priority channel.
3
Press the [J] and [K] keys to select the desired priority.
4
Press the [ ] or [ ] key to confirm your selection.
5
Press the [ ] key to exit scan programming.
39