Turning Off The Projector - NEC NP-PA1004UL-W User Manual

2-7. Turning off the Projector

To turn off the projector:
1. First, press the
projector cabinet or the STANDBY button on
the remote control.
The [POWER OFF / ARE YOU SURE ? / CARBON
SAVINGS-SESSION 0.000[g-CO2]] message will
appear.
2. Secondly, press the ENTER button or press
the (POWER) or the STANDBY button
again.
The light source will be turned off and the power
supply will be cut.
CAUTION
• Parts of the projector may become temporarily heated if the projector is turned off with the
POWER button or if the AC power supply is disconnected during normal projector operation.
Use caution when picking up the projector.
NOTE:
• While the POWER indicator is blinking blue in short cycles, the power cannot be turned off.
• You cannot turn off the power for 60 seconds immediately after turning it on and displaying an image.
• Do not unplug the power cord from the projector or from the power outlet while an image is being projected. Doing so could
deteriorate the projector's AC IN terminal or the power plug's contact. To turn off the AC power while an image is being projected,
use the power strip's switch, the breaker, etc.
• Do not disconnect the AC power supply to the projector within 10 seconds of making adjustment or setting changes and closing
the menu. Doing so can cause loss of adjustments and settings.
(POWER) button on the
2. Projecting an Image (Basic Operation)
37