NEC NP-PA1004UL-W User Manual page 183

[POWER OPTIONS]
[POWER-SAVING]
Select the standby mode:
ON
OFF
TIP:
• Even if [POWER-SAVING] is set to [ON], the projector goes to sleep in the following cases.
- [PC CONTROL(HDBaseT)] is set to [ON]
- [REMOTE SENSOR] is set to [HDBaseT]
- [HDBaseT OUT SELECT] is set to other than [OFF]
- When [AUTO POWER ON SELECT] is set to something other than [OFF] and a signal is being input to the HDMI1, HDMI2, DisplayPort
or COMPUTER terminal
- [WIRED LAN] → [INTERFACE] is set to [HDBaseT]
- [Extron XTP] is set to [ON]
- While the lens is moving
- When a temperature error or other error has occurred
• The [POWER-SAVING] setting is not changed by [RESET].
• [POWER-SAVING] ON/OFF does not affect the carbon meter's calculation of the amount of CO
Enabling Direct Power On [DIRECT POWER ON]
Turns the projector on automatically when the power cord is inserted into an active power outlet.
This eliminates the need to always use the POWER button on the remote control or projector cabinet.
WARNING
• The projector produces intense light. When turning on the power, make sure no one within
the projection range is looking at the lens.
This setting is to keep the standby power consumption to the minimum necessary.
The standby state changes automatically depending on the projector settings and the state and
duration of connected devices (→ page 191). The consumption power also changes according to
the standby state.
This is a setting with no functional restrictions during standby.
To maintain the sleep state, the power consumption is higher than when this mode is set to [ON].
153
5. Using On-Screen Menu
emission reduction.
2