NEC NP-PA1004UL-W User Manual page 32

• 360 dgeree free projection
This projector can be installed universally in every angle.
Note, however, that the separately sold option cover is required to be attached to the projector
depending on the installation angle of the projector.
For controlling fine inclination, use the tilt foot. Install an appropriate metal and a stand that
has enough strength to support the projector for controlling the installation angle.
Videos
• Wide range of input/output terminals (HDMI, DisplayPort, HDBaseT, etc.)
The projector is equipped with a variety of input/output terminals: HDMI (input × 2), DisplayPort,
HDBaseT (input × 1, output × 1), computer (analog), etc.
The projector's HDMI input, DisplayPort input terminals and HDBaseT Ports support HDCP.
HDMI and HDBaseT support HDCP 2.2/1.4
DisplayPort supports HDCP 1.3
• Simultaneous display of 2 images (PIP/PICTURE BY PICTURE)
Two images can be projected simultaneously with a single projector.
There are two types of layouts for the two images: [PIP] in which a sub-picture is displayed on
the main picture, and [PICTURE BY PICTURE] in which the main and sub pictures are displayed
next to each other.
• Multi-screen projection using multiple projectors
This projetor equips the HDBaseT IN/Ethernet and HDBaseT OUT/Ethernet ports. Multiple pro-
jectors in same brightness up to four units can be conneted in a daisy chain by a LAN* cable via
these terminals. A high quality picture is achieved by dividing and projecting high resolution
videos among the various projectors.
Furthermore, the boundaries of the screens are smoothed using an edge blending function.
* Use a commercially available CAT 5e STP cable or one in a higher specification.
• Seamless switch function for smoother screen changes when switching the signal
When the input connector is switched, the image displayed before switching is held so that that
the new image can be switched to without a break due to absence of a signal.
• Supports HDMI 3D format
This projector can be used to watch videos in 3D using commercially-available active shutter-
type 3D eyewear and 3D emitters that support XPANDVISION 3D.
Network
• Supports wired LAN
Equips the LAN and HDBaseT/Ethernet (RJ-45) ports. Utilizing a wired LAN connected with these
ports, it enables to control the projector by a computer.
1. Check the product overview, supplied items and part names
2