Honda HS1336iAS Owner's Manual page 99

3. Disconnect the negative (—) cable at the battery A negative (—) terminal and
put the tube on the terminal.
4. Disconnect the positive ( + ) cable at the battery B positive ( + ) terminal and
put the tube on the terminal.
5. Loosen the nuts and lock nuts holding the battery set plate.
6. Disconnect the battery joint cable at the battery B negative (—) terminal and
at the battery A positive ( + ) terminal.
NEGATIVE(-) CABLE
NUT
LOCK NUT
7. Remove the battery and clean the battery terminals and battery cable
terminals with a wire brush or sand paper.
Clean the battery with a solution of baking soda and warm water with care not
to get the solution or water in the battery cells. Dry the battery thoroughly.
SERVICING YOUR SNOW BLOWER
POSITIVE(+) CABLE
NEGATIVE(-) TERMINAL
POSITIVE(+) TERMINAL
(Two 12V batteries are connected in series/24V)
BATTERY JOINT CABLE
BATTERY SET PLATE
BATTERY B
BATTERY A
NEGATIVE(-)
TERMINAL
POSITIVE(+)
TERMINAL
TUBES
97