Honda HS1336iAS Owner's Manual page 100

SERVICING YOUR SNOW BLOWER
8. Reinstall the batteries in their original position.
9. Connect one battery joint cable terminal at the battery A positive ( + )
terminal, and connect the other cable terminal at the battery B negative (—)
terminal.
10.Reinstall the battery set plate and tighten the nuts.
11.Remove the tubes from the negative (—) post of battery A and the positive
(+) post of battery B. Connect the positive ( + ) cable at the battery B positive
( + ) terminal, and then the negative (—) cable at the battery A negative (—)
terminal.
12.Coat the battery terminals with terminal (dielectric) grease.
13.Reinstall the rear cover by aligning the grommets with the projections of the
rear cover, and tighten the knobs securely.
SPRING
Install the upper side of the rear cover
between the right and left springs.
When disconnecting the battery cable, be sure to disconnect the battery negative
(—) terminal first. Connect the positive (
terminal. Never disconnect the battery cables in the reverse order; that could cause a
short circuit if a tool contacts the terminals.
98
REAR COVER
GROMMET
) terminal first, then the negative (—)
KNOBS
REAR COVER
PROJECTION
GROMMET
PROJECTION