Table of Contents
Advertisement
Stratford Fireplace Installation and Operation Manual
2
GENERAL INFORMATION ON STRATFORD (OB04002)
2.1 APPLIANCE PERFORMANCE
Fuel type
Recommended heating area
Firebox volume
[*]
Maximum burn time
(2)
Maximum heat output
Overall heat output rate (min. to max.)
Average overall efficiency
Average overall efficiency
Optimum efficiency
(2)(6)
Average particulate emissions rate
(8)
Average CO
[*]
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft, heat loss
factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the
manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a
power failure.
(1)
Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn
time and maximum heat output.
(2)
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
Other performances are based on a fuel load prescribed by the standard. The specified loading density varies
between 7 lb/ft³ and 12 lb/ft
(3)
As measured per CSA B415.1-10 stack loss method.
(4)
Higher Heating Value of the fuel.
(5)
Lower Heating Value of the fuel.
(6)
Optimum overall efficiency at a specific burn rate (LHV).
(7)
This appliance is officially tested and certified by an independent agency.
(8)
Carbon monoxide.
8 ______________________________________________________________________
(1)
[*]
(dry cordwood)
(2)(3)
(3)
- EPA Cribs / Douglas Fir
(3)
- Dry cordwood
(7)
3
. The moisture content is between 19% and 25%.
Dry cordwood
2
750 to 2,100 ft
(70 to 195 m
3
3
2.5 ft
(0.071 m
)
9 h
75,000 BTU/h (22.0 kW)
11,500 BTU/h to 30,500 BTU/h (3.4 kW to 8.9 kW)
(4)
55.0% (HHV
)
To come% (HHV
(4)
)
75.0%
4.4 g/h (EPA / CSA B415.1-10)
To come
2
)
(5)
60.0% (LHV
)
To come% (LHV
(5)
)
3
3
and 20 lb/ft
.
Advertisement
Table of Contents
