Chimney Support Installation; Universal Roof Support; Universal Offset Support; Installation Instructions For Masonry Application - Osburn Stratford OB04002 Installation And Operation Manual

Table of Contents

Stratford Fireplace Installation and Operation Manual

8.8 CHIMNEY SUPPORT INSTALLATION

This support has three possible uses:

1. It must be used on a roof to support the chimney.

2. It may be used on a floor, ceiling or roof above an offset to support the chimney above the

offset.

3. It may be used on a floor, ceiling or roof as a supplementary support.

For roof support installation, refer to the instructions provided with the support by the chimney

manufacturer. Many manufacturers will provide the maximum height of chimney that can be

supported by the support. Make sure you respect those parameters.

This support is used to support the chimney above an offset. When the chimney offset is used to

pass through a wall, this support may be used on the wall to support the chimney. For offset

support installation, refer to the instructions provided with the support by the chimney

manufacturer. Many manufacturers will provide the maximum height of chimney that can be

supported by the support. Make sure you respect those parameters.

WARNING: BEFORE STARTING THE INSTALLATION, THE MASONRY CHIMNEY MUST BE

INSPECTED BY A QUALIFIED SWEEP.

The following requirements must be respected:

1. The chimney must be absolutely clear of any soot residue or creosote. Check for cracks, loose

or missing bricks that could inhibit correct installation of the liner.

2. The clearance to combustible must be a minimum of 1" between the outside of the masonry

and any wood framing or loose insulation.

3. The chimney must be built in accordance with the current building code.

4. No other appliance can be connected to the same chimney.

Installation:

The chimney must be relined with a stainless steel liner of the same diameter as the outlet of

the fireplace. For connection at 30

the liner (C) to the insulated chimney (A). Verify availability and installation instructions for this

connector with the chimney manufacturer.

64 _____________________________________________________________________

or 45° angle, a special connector (B) must be used to connect

Table of Contents