Table of Contents
Advertisement
Stratford Fireplace Installation and Operation Manual
Follow these steps:
1. Position the fireplace in its location. Temporarily install
the elbow or chimney section (A) on the top of the
fireplace and, using a level, mark with an oval the
location where the flue liner will enter the masonry
chimney.
2. In the middle of the oval, drill a hole in the masonry
chimney at 45 or 30.
3. Increase the size of the hole until a 45 or 30 insulated
liner adapter (B) can be easily slipped through.
4. Slide the liner (C) down from the top of the masonry
chimney until you reach the hole level.
5. Slip through the hole a 45 or 30 insulated liner adapter
and connect it to the liner.
6. Seal the opening around the liner with high temperature
refractory cement.
7. Then, follow the chimney manufacturer's instructions to
connect the extended liner section to the special
chimney connector.
Note: Make sure the liner exceeds at least 12" (30 cm) the
top of masonry chimney.
8.10 SUPPLY OF COMBUSTION AIR
In Canada, wood fireplaces are not required to have a supply of combustion air from outdoors
because research has shown that these supplies do not give protection against house
depressurization and may fail to supply combustion air during windy weather. However, to protect
against the risk of smoke spillage due to house depressurization, a carbon monoxide (CO)
detector/alarm is required in the room where the fireplace is installed. The CO detector will
provide warning if for any reason the wood fireplace fails to function correctly.
8.10.1 AIR SUPPLY IN CONVENTIONAL HOUSES
The safest and most reliable supply of combustion air for your wood fireplace is from the room in
which it is installed. Room air is already preheated so it will not chill the fire, and its availability is
not affected by wind pressures on the house. Contrary to commonly expressed concerns, almost
all tightly-sealed new houses have enough natural leakage to provide the small amount of air
needed by the fireplace. The only case in which the wood fireplace may not have adequate access
to combustion air is if the operation of a powerful exhaust device (such as a kitchen range
exhaust) causes the pressure in the house to become negative relative to outdoors.
If you do install an air supply through the wall of the house, be aware that its pressure can be
affected during windy weather. If you notice changes in wood fireplace performance in windy
weather, and in particular if smoke puffs from the fireplace, you should disconnect the outdoor air
duct from the fireplace and remove the duct. In some windy conditions, negative pressure at the
duct weatherhood outside the house wall may draw hot exhaust gases from the fireplace
backwards through the duct to outdoors. Check the outdoor air duct for soot deposits when the
full system is cleaned and inspected at least once each year.
_____________________________________________________________________ 65
Advertisement
Table of Contents
