Table of Contents
Advertisement
en Basic operation
Pour in detergent.
2.
→ "Detergent drawer", Page 21
If required, add the care product.
3.
Push in the detergent drawer.
4.
Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a If you start a programme with act-
ive oxygen, the drum lights up
after the programme starts and the
mist that is created can be seen.
Adding laundry
Notes
¡ Please read the information in the
"Safety" → Page 4 and "Preventing
material damage" → Page 11 sec-
tions to ensure that you use the
appliance safely.
¡ If you a start a programme with
active oxygen, you cannot add any
laundry after the programme has
started.
Press Start/Reload.
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry.
Add or remove laundry.
2.
Close the door.
3.
Press Start/Reload.
4.
46
Cancelling the programme
Once the programme has started,
you can cancel it at any time.
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Start/Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse/Freshen Up pro-
gramme.
– If the water level is high: Start
the Spin or Drain programme.
Remove the laundry.
3.
Resuming the programme
when the programme status
is Rinse Hold
Set the Spin or Drain programme.
1.
Press Start/Reload.
2.
Unloading the laundry
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Open the door.
1.
www.devicemanuals.eu
Advertisement
Table of Contents
