Table of Contents
Advertisement
Fault
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
The spin cycle runs several
times.
The programme duration
changes during the wash
cycle.
Cause
The water outlet hose is con-
nected too high.
Pump cover is not correctly
assembled.
Pump cover is not correctly
assembled.
Detergent dosage is too
high.
Unapproved extension in-
stalled on the water drain
hose.
You have not pressed Start/
Reload.
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
The programme operation is
optimised electronically.
This may change the pro-
gramme duration.
www.devicemanuals.eu
Troubleshooting en
troubleshooting
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 46
Install the water outlet hose at a
▶
maximum height of 1 metre.
→ "Technical specifications",
Page 74
Correctly assemble the pump
▶
cover.
Correctly assemble the pump
▶
cover.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
Remove any unapproved exten-
▶
sions from the water hose. Connect-
ing the appliance
Press Start/Reload.
▶
"Clean the water inflow filter"
▶
→ Page 58.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
63
Advertisement
Table of Contents
