Fault
"E:30 / -80"
"E:36 / -25 / -26"
"E:10 / -10"
"E:35 / -10"
All other error codes.
Water cooling
Malfunctions
Fault
The appliance is not work-
ing.
The programme does not
start.
Cause
Unapproved extension in-
stalled on the water drain
hose.
Drain pump is blocked.
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
There is water in the base
trough.
The appliance is leaking.
Malfunction
To protect the wastewater
pipes, the hot detergent
solution is cooled before be-
ing drained.
Cause
The mains plug of the power
cord is not plugged in.
The circuit breaker is faulty.
There has been a power cut.
You have not pressed Start/
Reload.
Door is not closed.
www.devicemanuals.eu
Troubleshooting en
troubleshooting
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
Remove any unapproved exten-
▶
sions from the water hose. Connect-
ing the appliance
→ "Cleaning the drain pump",
▶
Page 55
"Clean the water inflow filter"
▶
→ Page 58.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 71
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 71
Call the after-sales service.
▶
→ "Customer Service", Page 71
Wait until the detergent solution
▶
has cooled down.
troubleshooting
Connect the appliance to the power
▶
supply.
Check the circuit breaker in the
▶
fuse box.
Check whether the lighting in your
▶
kitchen or other appliances are
working.
Press Start/Reload.
▶
Close the door.
1.
61