Table of Contents
Advertisement
en Troubleshooting
Fault
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Drum jerks after the pro-
gramme starts.
Residual water is present in
the compartment
.
Vibrations and movement of
the appliance whilst spin-
ning.
Drum does not turn, water
does not flow in.
Heavy foam build-up
High spin speed not
reached.
64
Cause
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
This is caused by an internal
motor test.
Insert in compartment
blocked.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been
removed.
Load detection is active.
Detergent dosage is too
high.
A low spin speed is selected.
Less Ironing is activated.
www.devicemanuals.eu
troubleshooting
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Not a fault – no action required.
▶
→ "Cleaning the detergent drawer",
is
▶
Page 54
Aligning the appliance
▶
Secure the appliance feet. Aligning
▶
the appliance
Removing the transit bolts
▶
Not a fault – no action required.
▶
Note: The load detection can take up
to two minutes.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
The next time you run a wash cycle,
▶
set a higher spin speed.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 29
Advertisement
Table of Contents
