Table of Contents
Advertisement
en operation
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 28
Press
.
▶
The drum rotates and load detec-
a
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: "End" .
13.9 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
The programme is set.
¡
→ "Setting a programme", Page 28
The programme end time is set
¡
and activated.
→ "Buttons", Page 22
Press
.
1.
The activated programme end time
is paused.
Press
until the display shows
2.
the required programme end time.
Press
.
3.
The changed programme end time
is activated.
13.10 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press
30
To resume the programme, after
3.
the desired soaking time, press
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
5.
13.12 Cancelling the pro-
Press
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
– If the water level is high, start
Remove the laundry.
3.
→ "Unloading the laundry",
Page 31
.
.
.
.
gramme
.
the Skylning (Rinse) pro-
gramme.
the Centrifugering (Spin) pro-
gramme or select a suitable pro-
gramme for draining.
→ "Programmes", Page 23
Advertisement
Table of Contents
