Table of Contents
Advertisement
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 29
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the "Ready in" time.
a After the programme has ended,
the display shows: -0-.
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press
To resume the programme, after
3.
the desired soaking time, press
.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement: A programme has
started.
→ "Starting the programme",
Page 31
Press
.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
13.11 Cancelling the pro-
Press
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
– If the water level is high, start
Remove the laundry.
3.
→ "Unloading the laundry",
Page 31
13.12 Resuming the pro-
.
Requirements
¡ Rinse Stop is activated.
→ "Buttons", Page 22
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
Set the Spin programme or a pro-
1.
gramme for draining the water.
→ "Programmes", Page 24
Press
2.
13.13 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
13.14 Switching off the appli-
Press
1.
gramme
.
the Rinse programme.
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 24
gramme when the pro-
gramme status is Rinse
Hold
.
ance
.
operation en
31
Advertisement
Table of Contents
