Table of Contents
Advertisement
IMAGE menu
IMAGE menu
From the IMAGE menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor button or E NTE R button to
execute the item. Then perform it according to the
following table for selected port.
It e m
A S PE C T
O V E R S C A N
V PO S ITIO N
H PO S ITIO N
(continued on next page)
4 0
Using the ▲/▼ buttons switches the mode for aspect ratio.
NORMAL ó 4:3 ó 16:9 ó 16:10 ó 14:9 ó ZOOM ó NATIVE
• The NORMAL mode keeps the original aspect ratio of the signal.
Using the ◄/► buttons adjusts the over-scan ratio.
Small (It magnifies picture) ó Large (It reduces picture)
Using the ◄/► buttons adjusts the vertical position.
Down ó Up
• Over-adjusting the vertical position may cause noise to appear on
the screen. If this occurs, please reset the vertical position to the
default setting. Pressing the R E S E T button when the V POSITION
is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, the range of
this adjustment depends on OVER SCAN (above) setting. It is not
possible to adjust when OVER SCAN is set to 10.
Using the ◄/► buttons adjusts the horizontal position.
Right ó Left
• Over-adjusting the horizontal position may cause noise to appear on
the screen. If this occurs, please reset the horizontal position to the
default setting. Pressing the R E S E T button when the H POSITION is
selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, the range of
this adjustment depends on OVER SCAN (above) setting. It is not
possible to adjust when OVER SCAN is set to 10.
D e s c r i p t i o n
Advertisement
Table of Contents
