Table of Contents
Advertisement
It e m
S E R V IC E
( c o n t i n u e d )
(continued on next page)
Selecting this item displays COMMUNICATION
menu.
In this menu, you can configure the serial
communication settings of the projector using the
C O NTR O L port.
• Select an item using the cursor buttons ▲/▼.
Then pressing the ► button opens the submenu
for the setting item you selected. Or, pressing
the ◄ button instead of the ► button makes the
menu back to the previous one without changing
the setup. Each submenu can be operated as
described above.
• When COMMUNICATION TYPE (below) is
set to OFF, the other items in COMMUNICATION
menu are invalid.
• For the function of serial communication, refer to
the Ne t w o r k G u i d e .
C O M M UNIC A TIO N
C O M M UNIC A TIO N TY PE
Select the communication type for transmission via
the C O NTR O L port.
NETWORK BRIDGE: Select this type, if it is
OFF: Select this mode to receive RS-232C
• OFF is selected as the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSION METHOD (70).
D e s c r i p t i o n
NETWORK BRIDGE (WIRELESS)
NETWORK BRIDGE (WIRED)
OFF
required to control an external device as a
network terminal, via this projector from the
computer. Select WIRELESS or WIRED as your
network connection mode.
The C O NTR O L port does not accept RS-232C
commands (7 . Ne t w o r k B r i d g e F u n c t i o n in
the Ne t w o r k G u i d e ).
commands using the C O NTR O L port.
OPTION menu
6 9
Advertisement
Table of Contents
