Table of Contents
Advertisement
SETUP menu
Wake-On LAN (WOL) function
If you select NETWORK(WOL) in SETUP menu > STANDBY MODE, you can
use the Wake-On LAN(WOL) function of wired network while saving power
consumption in standby state.
O p e r a t i o n
Various communication functions can be used after the projector goes into
NORMAL standby mode by receiving WOL Magic packet in standby state.
However, the projector automatically goes back to NETWORK(WOL) standby
mode with less power consumption if 10 minutes have passed after the
projector goes into NORMAL standby mode by WOL Magic packet.
It takes about 1 minute on a wired network or about 2 minutes on a wireless
network until communication functions are available after WOL Magic packet
has been received.
WOL Magic packet
Item
Network
Protocol
Destination address
Destination port number
WOL Magic packet
(Example) WOL Magic packet for MAC Address: 01:02:03:04:05:06
FF:FF:FF:FF:FF:FF: 01:02:03:04:05:06: 01:02:03:04:05:06: 01:02:03:04:05:06:
01:02:03:04:05:06: 01:02:03:04:05:06: 01:02:03:04:05:06: 01:02:03:04:05:06:
01:02:03:04:05:06: 01:02:03:04:05:06: 01:02:03:04:05:06: 01:02:03:04:05:06:
01:02:03:04:05:06: 01:02:03:04:05:06: 01:02:03:04:05:06: 01:02:03:04:05:06:
01:02:03:04:05:06:
NOTICE
Supported WOL Magic packet is a packet to be sent to broadcast address.
General routers may not forward a packet of broadcast address to a device
with a different network address by default.
If you use a router like this, WOL function cannot be used for the projector that
is not in the same network address.
Consult with your network administrator about router settings.
This function is available only in wired network and is not supported in wireless
network.
(continued on next page)
5 0
Specifications
Wired network only
UDP
Broadcast address
Arbitrary
A packet using MAC address of wired LAN of the projector
(FF:FF:FF:FF:FF:FF(6 bytes))
followed by 102-byte data with MAC Address(6 bytes)
repeated 16 times
Advertisement
Table of Contents
