Table of Contents
Advertisement
It e m
O S D M E S S A G E
S TA ND B Y
O UTPUT
Using the ▲/▼ buttons turns on/off the message function.
• To change this function, follow the steps below.
1. Press the O S D M S G
2. The INHIBIT OSD will be displayed.
While this OSD is displayed, press the O S D M S G
on the remote control.
3. Toggle and change the function.
NORMAL ó SILENT ó INHIBIT
■SILENT : The following message functions do not work.
"AUTO IN PROGRESS" while automatically adjusting.
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"INVALID SCAN FREQ."
"NOT AVAILABLE"
"Searching...." while searching for the input.
"Detecting...." while an input signal is detected.
The indication of the input signal displayed by changing.
The indication of the aspect ratio displayed by changing.
The indication of the PICTURE MODE displayed by changing.
The indication of the ACTIVE IRIS displayed by changing.
The indication of the MY MEMORY displayed by changing.
The indication of "FREEZE" and "II" while freezing the screen by
pressing the F R E E Z E button.
The indication of the TEMPLATE displayed by changing.
The indication of the ECO MODE displayed by changing.
■INHIBIT : All message functions do not work.
The only buttons will function are as below.
STANDBY, ON
AUDIO OUT
To select the sound output in the standby mode.
• When the STANDBY MODE is set to NETWORK(WOL) or
SAVING, the STANDBY OUTPUT menu cannot be operated.
• When the MHL STANDBY PWR. (45) is set to OFF, MHL audio
is unavailable in the standby mode.
D e s c r i p t i o n
button on the remote control for 3 sec.
SETUP menu
button again
5 1
Advertisement
Table of Contents
