Table of Contents
Advertisement
Remote control
About the remote control signal
The remote control works with the projector's remote
sensor. This projector has a remote sensor on the front.
The sensor senses the signal within the following range
when the sensor is active:
60 degrees (30 degrees to the left and right of the sensor)
within 3 meters about.
NOTE
• The remote control signal refl ected in the screen or the like may be available.
If it is diffi cult to send the signal to the sensor directly, attempt to make the signal refl ect.
• The remote control uses infrared light to send signals to the projector (Class 1
LED), so be sure to use the remote control in an area free from obstacles that
could block the remote control's signal to the projector.
• The remote control may not work correctly if strong light (such as direct sun
light) or light from an extremely close range (such as from an inverter fl uorescent
lamp) shines on the remote sensor of the projector. Adjust the position of
projector avoiding those lights.
Changing the frequency of remote control signal
The accessory remote control has the two choices on signal frequency Mode
1:NORMAL and Mode 2:HIGH. If the remote control does not function properly,
attempt to change the signal frequency.
In order to set the Mode, please keep pressing the combination of two buttons
listed below simultaneously for about 3 seconds.
(1) Set to Mode 1:NORMAL
V O L UM E - and R E S E T buttons
(2) Set to Mode 2:HIGH
M A G NIF Y O F F and E S C buttons
Please remember that the REMOTE
FREQ. in the SERVICE item of the OPTION menu (68) of the projector to be
controlled should be set to the same mode as the remote control.
1 8
(2)
INPUT
ASPECT
M A G NIF Y
MAGNIFY
ON
OFF
O F F button
PAGE
UP
DOWN
E S C
ESC
button
OSD MSG
(approx.)
(1)
MYBUTTON
1
2
PbyP
AUTO
FREEZE
V O L UM E -
FOCUS
ZOOM
VOLUME
+
+
+
-
-
-
button
GEOMETRY
PICTURE
MUTE
INTERACTIVE
NETWORK
BLANK
R E S E T
MENU
ENTER
button
RESET
Advertisement
Table of Contents
