Table of Contents
Advertisement
OPTION menu
It e m
S E R V IC E
( c o n t i n u e d )
(continued on next page)
7 0
S E R IA L S E TTING S
Select the serial communication condition for the
C O NTR O L port.
Select settings of BAUD RATE and PARITY
depending on your environment.
TR A NS M IS S IO N M E TH O D
Select the transmission method for communication by
the NETWORK BRIDGE from the C O NTR O L port.
HALF-DUPLEX: This method lets the projector
FULL-DUPLEX: This method lets the projector
• HALF-DUPLEX is selected as the default setting.
• If you select HALF-DUPLEX, check the setting of
the item RESPONSE LIMIT TIME (below).
C O M M UNIC A TIO N
R E S PO NS E L IM IT TIM E
( c o n t i n u e d )
Select the time period to wait for receiving
response data from other device communicating by
the NETWORK BRIDGE and the HALF-DUPLEX
through the C O NTR O L port.
OFF: Select this mode if it is not required to check
1s /2s /3s: Select the time period to keep the
• This menu is available only when the NETWORK
BRIDGE is selected for the COMMUNICATION
TYPE and the HALF-DUPLEX is selected for the
TRANSMISSION METHOD (above).
• OFF is selected as the default setting.
D e s c r i p t i o n
HALF-DUPLEX ó FULL-DUPLEX
make two way communication, but only one
direction, either transmitting or receiving data, is
allowed at a time.
make two way communication, transmitting and
receiving data at the same time.
OFF ó 1s ó 2s ó 3s
the responses from the device that the projector
sends data to. In this mode, the projector can
send out data from the computer continuously.
projector waiting for response from the device
that the projector sends data to. While waiting the
response, the projector does not send out any
data from the C O NTR O L port.
Advertisement
Table of Contents
