Table of Contents
Advertisement
It e m
INS TA L L A TIO N
S TA ND B Y M O D E
(continued on next page)
Pressing the ►button displays the dialog for changing the
INSTALLATION setting.
FRONT / DESKTOP
REAR / DESKTOP
REAR / CEILING
FRONT / CEILING
Use the ▲/▼ buttons to select the desired setting on the
INSTALLATION dialog, and press the E NTE R button of the remote
control or the INPUT button of the projector to execute.
This function is unavailable when TRANSITION DETECTOR (
is ON.
Using ▲/▼ buttons switches the standby mode setting.
NORMAL : For using communication functions in the standby
mode.
NETWORK(WOL) : For using Wake on LAN (WOL) function
SAVING : Reduces power consumption minimally.
• When NETWORK (WOL) or SAVING is selected, the following
restrictions apply.
- The RS-232C communication control except to turn the projector
on are disabled while the projector is in the standby mode. If the
COMMUNICATION TYPE in the COMMUNICATION menu is
set to NETWORK BRIDGE, all of the RS-232C commands are
disabled(69).
- STANDBY OUTPUT is invalid.
- The Projector control via HDMI function is disabled while the
projector is in the standby mode.
- SCHEDULE function (Ex. POWER-ON) in the standby mode will
not be operated.
- The MHL STANDBY PWR. menu cannot be operated and MHL
power feeding is unavailable with standby mode(45).
- It takes a while until the projector is available after starting up.
- The USB connection is disabled while the projector is in standby
mode.
• When NETWORK (WOL) is selected, only Wake on LAN (WOL)
on wired LAN is accepted while the projector is in the standby
mode.
D e s c r i p t i o n
on wired network while reducing power
consumption.
SETUP menu
76
)
4 9
Advertisement
Table of Contents
