Table of Contents
Advertisement
OPTION menu
It e m
D IR E C T PO W E R
O N
A UTO
PO W E R
O N
A UTO
PO W E R
O F F
(continued on next page)
6 0
Using the ▲/▼ buttons turns on/off the DIRECT POWER ON
function.
ON ó OFF
When set to the ON, the lamp in projector will be automatically turned
on without the usual procedure (20), only when the projector is
supplied with the power after the power was cut while the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
• After turning the lamp on by the DIRECT POWER ON function,
if neither input nor operation is detected for about 30 minutes, the
projector is turned off, even though the AUTO POWER OFF function
(below) is disabled.
When the projector is in the standby mode and detects the video
signal input from external device, this function starts up the projector
to display the image automatically on the screen.This function can
be enabled by selecting an input referring to the displayed list.
• This function is unavailable when STANDBY MODE is set to
NETWORK(WOL) or SAVING.
• This function may work unintentionally by connected external
device.
Using the ▲/▼ buttons adjusts the time to count down to
automatically turn the projector off.
Long (max. 99 minutes) ó Short (min. 0 minute = DISABLE)
When the time is set to 0, the projector is not turned off
automatically.
When the time is set to 1 to 99, and when the passed time with
no-signal or an unsuitable signal reaches at the set time, the
projector lamp will be turned off.
If one of the projector's buttons or the remote control buttons
is pressed or one of the commands (except get commands) is
transmitted to the C O NTR O L port during the corresponding time,
projector will not be turned off.
Please refer to the section Tu r n i n g o f f t h e p o w e r (21).
D e s c r i p t i o n
Advertisement
Table of Contents
