Table of Contents
Advertisement
Chapter 25 Remote Management
Table 86 Maintenance > Remote MGMT > WWW (continued)
LABEL
Apply
Cancel
25.3 Telnet Screen
You can use Telnet to access the Device's command line interface. Specify which interfaces allow
Telnet access and from which IP address the access can come.
Click Maintenance > Remote MGMT > Telnet tab to display the screen as shown.
Figure 143 Maintenance > Remote MGMT > Telnet
The following table describes the labels in this screen.
Table 87 Maintenance > Remote MGMT > Telnet
LABEL
Server Port
Server Access
Secured Client IP
Address
Apply
Cancel
208
DESCRIPTION
Click this to save your changes.
Click this to restore your previously saved settings.
DESCRIPTION
This displays the service port number for accessing the Device. If the number is grayed
out, it is not editable.
Select the interfaces through which a computer may access the Device using this service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule.
A secured client is a "trusted" computer that is allowed to communicate with the Device
using this service.
Select All to allow any computer to access the Device using this service.
Choose Range to just allow the computers with an IP address in the range that you
specify to access the Device using this service.
Click this to save your changes.
Click this to restore your previously saved settings.
VMG1312-T10C User's Guide
Advertisement
Table of Contents
