ZyXEL Communications VMG1312-T10C User Manual page 142

Chapter 13 Filter
Table 59 Security > Filter > IPv6/MAC Filter (continued)
LABEL
Destination IPv6
Address
Destination Prefix
Length
ICMPv6 Type
Protocol
Source MAC
Address
IPv6 / MAC Filter Listing
IPv6 / MAC Filter
Rule Index
#
Active
Interface
Direction
ICMPv6 Type
Src IP/PrefixLength
Dest IP/
PrefixLength
Mac Address
Protocol
Apply
150
DESCRIPTION
Enter the destination IPv6 address of the packets you wish to filter. This field is ignored
if it is ::.
Enter the prefix length for the destination IPv6 address.
Select one of the following ICMPv6 message types to filter.
1 / Destination Unreachable: 0 - no route to destination; 1 - communication with
destination administratively prohibited; 3 - address unreachable; 4 - port unreachable
2 / Packet Too Big
3 / Time Exceeded: 0 - hop limit exceeded in transit; 1 - fragment reassembly time
exceeded
4 / Parameter Problem: 0 - erroneous header field encountered; 1 - unrecognized
Next Header type encountered; 2 - unrecognized IPv6 option encountered
128 / Echo Request
129 / Echo Response
130 / Listener Query - Multicast listener query
131 / Listener Report - Multicast listener report
132 / Listener Done - Multicast listener done
143 / Listener Reportv2 - Multicast listener report v2
133 / Router Solicitation
134 / Router Advertisement
135 / Neighbor Solicitation
136 / Neighbor Advertisement
137 / Redirect - Redirect message
This is the (upper layer) protocol that defines the service to which this rule applies. By
default it is ICMPv6.
This field is only available when you select MAC in the Rule Type field.
Enter the MAC address of the packets you wish to filter.
Select the index number of the filter set from the drop-down list box.
This is the index number of the rule in a filter set.
This field shows whether the rule is activated.
This is the interface that the rule applies to.
The filter set applies to this traffic direction.
The ICMPv6 message type to filter.
This displays the source IPv6 address and prefix length.
This displays the destination IPv6 address and prefix length.
This is the MAC address of the packets being filtered.
This is the (upper layer) protocol that defines the service to which this rule applies. By
default it is ICMPv6.
Click this to save your changes.
VMG1312-T10C User's Guide