The Telnet Screen - ZyXEL Communications EMG1302-R10A User Manual

Table 56 Configuration > Management > Remote MGMT > WWW (continued)
LABEL
Access Status
Secured Client IP
Address
Apply
Cancel

19.5 The Telnet Screen

You can use Telnet to access the EMG1302-R10A's command line interface. Specify which interfaces
allow Telnet access and from which IP address the access can come.
Click Configuration > Management > Remote MGMT > Telnet to display the screen as shown.
Figure 77 Configuration > Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
Table 57 Configuration > Management > Remote MGMT > Telnet
LABEL
Port
Access Status
Secured Client IP
Address
Apply
Cancel
EMG1302-R10A User's Guide
DESCRIPTION
Select the interface(s) through which a computer may access the EMG1302-R10A using
this HTTP service.
Select All to allow all computers to access the EMG1302-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG1302-R10A.
Click Apply to save your changes back to the EMG1302-R10A.
Click Cancel to exit this screen without saving.
DESCRIPTION
You may change the server port number for a service if needed. However you must use
the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the EMG1302-R10A using
this service.
Select All to allow all computers to access the EMG1302-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG1302-R10A.
Click Apply to save your changes back to the EMG1302-R10A.
Click Cancel to exit this screen without saving.
Chapter 19 Remote Management
137