Daewoo Solar 225LC-V Shop Manual page 402

4. Insert ball bearing (21) into hub (1).
5. Insert outer races of three roller bearings
(22).
6. Install hold flange (3) at spindle (2).
7. Coat locktite #638 at spindle (2) threads.
8. Place flat washers (37) in the three bolt
holes of the flange (3).
Tightening Torque:
20 kg•m (145 ft lb).
9. Hammer six parallel pins with an air chisel
until it reaches pin hole bottom.
10. Tighten allen head bolt (19) to specified
torque.
Tightening Torque:
72.3 kg•m (523 ft lb).
S0707330
Page 44
Return to Master Table of Contents
Figure 79
Figure 80
Figure 81
Figure 82
Travel Motor (With Gearbox) (GM35VL)