Adjusting The Steering Cable Tension - MotorGuide X5 Series Manual

3. Install the washer (and anode, for saltwater models) onto the propeller
shaft, then install the propeller nut. Use a wrench or a socket and ratchet
to tighten the propeller nut until it is snug, then tighten the nut another 1/4
turn.
IMPORTANT: Do not overtighten the propeller nut, or damage to the propeller
or propeller pin may occur.

Adjusting the Steering Cable Tension

Neglecting to inspect, maintain, or repair your trolling motor can result in
product damage or serious injury or death. Do not perform maintenance or
service on your trolling motor if you are not familiar with the correct service
and safety procedures.
The cable tension on the X5 trolling motor is preset at the factory. With time
and use, the cables may stretch slightly, requiring occasional adjustment. The
following procedure explains how to adjust the steering cable tension.
Use care while adjusting the steering cable tension. Excessive cable tension
will cause premature wear to the cables and pulleys, while excessively loose
tension may cause the cables to jump off of the pulleys, resulting in a loss of
steering control.
1. Remove the foot pedal from the boat deck if it has been secured with
screws.
2. Adjust the cable tension by turning the cable tension screw clockwise to
increase tension, and counterclockwise to decrease tension. Adjust the
cable tension screw to the specified torque value.
eng
MAINTENANCE
a
b
c
d
62099
WARNING
!
33
Saltwater model shown
a - Propeller
b - Anode (saltwater models
only)
c - Washer
d - Propeller nut