Ir Remote Control Operations; Pairing (Enabling) The Ir Remote To A Specific Device (Optional) - HIKVISION DS-96000NI-I16 Series: DS-96000NI-I16/H Series User Manual

3 USB interface
4 Panel lock
5 HDD
indicator

1.2 IR Remote Control Operations

The device may also be controlled with the included IR remote control, shown in Figure 1-3.
Batteries (2×AAA) must be installed before operation.
The IR remote is set at the factory to control the device (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
devices. You may also pair an IR Remote to a specific device by changing the Device ID#, as follows:
1.2.1 Pairing (Enabling) the IR Remote to a Specific Device
(optional)
You can pair an IR Remote to a specific device by creating a user-defined Device ID#. This feature is
useful when using multiple IR Remotes and devices.
On the device:
Step 1 Go to System > General.
Step 2 Type a number (255 digits maximum) into the Device No. field.
On the IR Remote:
Step 3 Press the DEV button.
Step 4 Use the Number buttons to enter the Device ID# that was entered into the device.
Step 5 Press Enter button to accept the new Device ID#.
Network Video Recorder User Manual

Solid red: at least one HDD is installed
HDD

Unlit: no HDD is detected.

Blinking red: HDD is reading/writing.
Tx/Rx Blinking blue indicates network communication is
normal.
Ready Solid blue indicates device runs properly.
Alarm Solid red indicates alarm occurs.
Universal Serial Bus (USB) ports for additional
devices such as USB mouse and USB Hard Disk Drive
(HDD).
Locks or unlocks the panel by the key.
sequence Shows the HDD installation slot.
18