Ir Remote Control Operations; Pairing (Enabling) The Ir Remote To A Specific Device (Optional) - HIKVISION DS-8132HQHI-K8 User Manual

No. Icon
1
2
3
4
5 USB Interface

IR Remote Control Operations

The device may also be controlled with the included IR remote control, shown in Figure 1-6.
Batteries (2×AAA) must be installed before operation.
The IR remote is set at the factory to control the device (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
devices. You may also pair an IR Remote to a specific device by changing the Device ID#, as follows:
Pairing (Enabling) the IR Remote to a Specific Device
(optional)
You can pair an IR Remote to a specific device by creating a user-defined Device ID#. This feature is
useful when using multiple IR Remotes and devices.
On the device:
Go to System > General.
Type a number (255 digits maximum) into Device No.
On the IR Remote:
Press DEV.
Use the Number buttons to enter the Device ID# that was entered into the device.
Press Enter to accept the new Device ID#.
Network Video Recorder User Manual
Table 1-4 Front Panel Description
Description
Turns white when DVR is powered up.
Turns red when data is being read from or written to
HDD.
Flashes white when the network is well-connected.
Receiver for IR remote control.
Universal Serial Bus (USB) ports for additional devices
such as USB mouse and USB Hard Disk Drive (HDD).
30