Figure 14 Ip-Reach Initialization Screen - Raritan Paragon II Deployment Manual

Hide thumbs

Table Of Contents

Table of Contents

4: IP-R

M1, M2, TR364

HAPTER

EACH

to IP-Reach from outside the LAN difficult, since the dynamically assigned IP address

must be known in order to initiate a connection.

♦ NO (default): Assigns a fixed IP address to the IP-Reach unit (recommended).

IP Address: Enter the IP address for IP-Reach given by your Network

Administrator.

b. Subnet Mask: Enter a Subnet Mask provided by your Network

Administrator.

Default Gateway: Enter the Default Gateway if your Network Administrator

specifies one.

Enable Modem Interface: Enables Dial-up Modem access (default: YES).

D. Enable Web Browser Interface: Enables web browser access to IP-Reach. Use the

default value YES.

E. Use Default TCP Port 5000:

YES (default): Utilizes the default port 5000. Use the default value.

ii.

NO: Enter an alternate port number.

Note: To access IP-Reach from beyond a firewall, your firewall settings must enable two-way

communication through the default port 5000 or a non-default port configured above

Important: The Paragon II System Controller communicates with the IP-Reach

units through TCP port 5000 only. Therefore, set the TCP port number to 5000

if you want a P2SC unit to manage the Paragon II Base Unit where the IP-

Reach units are associated. Otherwise, the P2SC unit cannot auto discover

the IP-Reach units.

4. Press CTRL+S to save entries. The Main Menu appears.

5. On the Main Menu, select R Restart or shutdown the IP-Reach, and press ENTER .

6. When prompted, press the letter R on your keyboard to restart IP-Reach.

7. IP-Reach will restart and the IP-Reach Initialization screen appears upon boot up.

8. IP-Reach is now ready for connection into the Paragon II and CommandCenter Integration

configuration.

Note: Repeat these steps for every IP-Reach unit in your Paragon II and CommandCenter

Integration configuration. In the context of a single "layer" (see Appendix B: Sample

Configurations, configure one TR364 IP-Reach and one M2 IP-Reach).

UST-IP I

AND

NSTALLATION AND