Setting Command - Saluki SPS8 Series User Manual

Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
12.560V.
Command [:]MEASure:CURRent?
Command [:]MEASure:CURRent? is used to read output current value.
Return command: Numeric
Return parameters Unit: A
Example:
Sending command [:]MEAS:CURR?, if return command is 1.245, it means the present output current is
1.245A.
Command [:]MEASure:DVM?
Command [:]MEASure: DVM? is used to read input voltage of the voltmeter in the power supply.
Return command: Numerical
Return parameters Unit: V
Example:
Sending command [:]MEAS:DVM?, if return command is12.560, it means the current voltmeter input voltage
is 12.560V.
Command [:]MEASure:VCM?
Command [:]MEASure:VCM? is used to read three value: output voltage value, output current value, and
input voltage of the voltmeter in the power supply.
Return command: Numerical list, using cormer(,) among the three values
Return parameters Unit: V and A
Example:
Sending command [:]MEAS:VCM?, if return command is 10.0000,0.00000,5.0000, it means the present output
voltage is 10.0000V, the present output current is 0.00000A, and the current voltmeter input voltage is 5.0000V.

6.2.4 Setting Command

Command [:]OUTPut <bool>
1.Command [:]OUTPut <bool> is used to set the output ON/OFF status.
Return command: None
Parameters: bool-type parameter (0-OFF, 1-ON)
Example:
If sending command [:]OUTP 1, the power supply output is ON if you set successfully.
2.Related command [:]OUTPut?, to query output status of power supply.
Return command parameter: <bool>.
Command [:] MODE <mode>
1. Command [:]MODE <mode> is used to set the power operating mode. That is, command set mode or
sequential list mode, or milliohmmeter mode.
34