Preliminary Checkout; If The Power Supply Does Not Turn On - Saluki SPS8 Series User Manual

③ 9-pin serial port interface connector
④ line voltage selection switch (110 VAC or 220 VAC)
⑤ AC input connector

3.2 Preliminary Checkout

The following steps help you verify that the power supply is ready for use.
1. Check the list of supplied items
Verify that you have received the following items with your power supply. If anything is missing, contact your
nearest sales office.
One power cord for your location

One CD (only when you have bought communication accessories)

One communication cable (only when you have bought communication accessories)

One test line (only SPS811 ,SPS812 ,SPS813, SPS831 have the test line)

2．Connect the power cord and turn on the power supply
When you turn on the power supply, the VFD display screen will light up briefly and the power supply
performs its power-on self-test. Please check if there is any stroke loss on VFD display.
Warning:Your power supply is equipped with a 3-wire grounding type power cord. The power
supply is grounded only when the power-line cord is plugged into an appropriate receptacle. Do not
operate your power supply without adequate cabinet ground connection.

3.3 If the Power Supply Does Not Turn On

Use the following steps to help solve problems you might encounter when turning on the instrument.
1. Verify that there is AC power to the power supply.
First, verify that the power cord is firmly plugged into the power receptacle on the rear panel of the power
supply. You should also make sure that the power source you plugged the power supply into is energized. Then,
verify that the power supply is turned on.
2. Verify the power-line voltage setting.
The line voltage is set to the proper value for your country (110VAC or 220VAC) when the power supply is
shipped from the factory. Change the voltage setting if it's not correct.
3. Verify that the correct power-line fuse is installed.
If the fuse was damaged, please see the table below to replace the fuse for your power supply.
Tel: 886.909 602 109 Email: sales@salukitec.com
13
www.salukitec.com