Rubber Rollers; Cleaning The Print Roller - Novexx Solutions 64 Series User Manual

03/13 Rev. 5.08-01

Rubber rollers

1. Switch off the device.
2. Pull out the mains plug.
3. Remove material and ribbon.
4. Only dispenser version: Remove the dispensing edge to gain easier access
5. Unscrew the two thumb screws on the print head mounting until the entire
 See paragraph

6. Now the print roller can be easily accessed from ahead. The rollers should
USER MANUAL
64-xx – 64-xx Dispenser

Cleaning the print roller

to the print roller. To to so, unscrew both holding screws (1) ().
Fig. 3 When using a 64-xx dispenser or
Chess x dispenser, remove the
dispensing edge to gain easier
access to the print roller.
print head mounting can be rotated upwards on the contact shaft.
"Cleaning the print
The print head may or does not need to be removed. Mark the position of
the printhead on the axle, if it is not flushed against the inner or outer
plastic ring.
be turned gradually in order to clean them properly.
Fig. 4 Rotate the printhead upwards
befor cleaning it.
Servicing and Maintenance
1
head" on page 5.
9
1