Cleaning The Dispenser-Feed-Roller - Novexx Solutions 64 Series User Manual

03/13 Rev. 5.08-01
7. After cleaning, return the print head mounting to its old position and

8. Before switching on the device, check whether the print head cable is still

1. Switch off the device.
2. Pull out the mains plug.
3. Remove material and ribbon.
4. Pull out the pull-out module (, left side).
 Read in any case paragraph "Inserting material" in topic section "Setup"!
5. Turn the feed roller stepwise while cleaning it using a cloth (Fig. 6, right
6. Remount the pull-out module.
USER MANUAL
64-xx – 64-xx Dispenser
retighten the thumb screws.
Press the thumb screw on the tapered edge of the square axle and ensure
the exact positioning of the print head mounting on the axle. Also pay
attention to the position of the print head in relation to the edge of the label.
Basic factory settings: Flush against the inner black plastic plug.
properly connected. If this is not the case, plug in the cable correctly.

Cleaning the dispenser-feed-roller

Only for 64-xx dispenser!
Fig. 6 Left side: pulling out the pull-out module; right side: cleaning the dispenser-feed-roller
using roller cleaner.
side) and rubber cleaner until the entire roller is free of residue.
Servicing and Maintenance
11