Cleaning The Feed Roller - Novexx Solutions 64 Series User Manual

03/13 Rev. 5.08-01

7. After cleaning, return the print head mounting to its old position and

8. Before switching on the device, check whether the print head cable is still
1. Switch off the device.
2. Pull out the mains plug.
3. Remove material and ribbon.
4. Remove the printhead.
 For detailed information refer to chapter
5. Turn the feed roller stepwise while cleaning it using a cloth (Fig. 5) and

USER MANUAL
64-xx – 64-xx Dispenser
CAUTION! - Only clean the print roller with a dust-free cloth and roller
cleaner. Never use knives or sharp-edged objects to clean the rollers!
Keeping impurities and dirt of any description away from the printing area
generally increases the running performance of the printer, and especially
that of the print head. The print image is also adversely affected by dirt and
other impurities.
retighten the thumb screws.
Press the thumb screw on the tapered edge of the square axle and ensure
the exact positioning of the print head mounting on the axle. Also pay
attention to the position of the print head in relation to the edge of the label.
Basic factory settings: Flush against the inner black plastic plug.
properly connected. If this is not the case, plug in the cable correctly.

Cleaning the feed roller

Every now and then, the feed roller and the contact pressure rollers should
be cleaned.
page 6.
rubber cleaner until the entire roller is free of residue.
Shift the front material guiding (1) and the contact pressure rollers (2) for
better access to the roller.
Fig. 5 In order to clean the feed roller
remove the printhead and shift
material guiding (1) and contact
pressure rollers (2) aside.
Servicing and Maintenance
"Changing the print head" on
2
1
10