Installing The Rear I/O Board - Dell Latitude 5430 Rugged Service Manual
Hide thumbs
Also See for Latitude 5430 Rugged:
- Service handbook (110 pages) ,
- Service manual (109 pages) ,
- Setup and specifications (31 pages)
Table of Contents
Advertisement
Steps
1. Peel the adhesive tape and unroute the cables from the routing channels on the system chassis.
2. Disconnect the rear I/O flat printed cable and remove the two (M2.5x5) screws that secure the rear I/O board to the
system board.
NOTE:
Disconnect the GPS cable and tilt the rear I/O board at an angle to remove it.
Installing the rear I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear I/O board and provides a visual representation of the installation
procedure.
Removing and installing components
65
- Quick Links:
- Memory Modules
Hide quick links:
Advertisement
Table of Contents
