Display Bezel; Removing The Display Bezel - Dell Latitude 5430 Rugged Service Manual

Steps
1. Replace the four (M3x7, T8) epoxy screws that secure the display assembly to the system chassis and close the lid.
2. Replace the two (M2.5x7) screws that secure the left/right hinge covers to the system chassis.
3. Replace the two (M3x7, T8) epoxy screws and two (M2.5x5) screws that secure the hinge covers to the system chassis.
Next steps
1. Install the system board.
2. Install the heat-sink (UMA)
3. Install the fan.
4. Install the rear I/O board.
5. Install the dock I/O board.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the Wi-Fi I/O board.
9. Install the base cover.
10. Install the keyboard.
11. Install the primary M.2 2280 solid state drive
12. Install the battery.
13. Follow the procedure in

Display bezel

Removing the display bezel

Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive
4. Remove the keyboard.
92 Removing and installing components
or heat-sink (discrete).
or primary M.2 2230 solid state
after working inside your
before working inside your
or
computer.
computer.
primary M.2 2230 solid state
drive.
drive.