Heat Sink; Removing The Heat-Sink - Dell Latitude 5430 Rugged Service Manual

Next steps
1. Install the base cover.
2. Install the primary M.2 2280 solid state drive
3. Install the battery.
4. Follow the procedure in

Heat sink

Removing the heat-sink

Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive
4. Remove the base cover.
5. Remove the Wi-Fi I/O
6. Remove the WLAN.
7. Remove the dock I/O
About this task
The following images indicate the location of the heat-sink and provide a visual representation of the removal procedure.
Steps
1. Remove the three (M2x3.5) and four (M2x6) screws (in reverse order, 7->6->5->4->3->2->1) that secure the heat-sink to
the system board.
2. Lift the heat-sink from the system chassis.
or
after working inside your
before working inside your
board.
board.
primary M.2 2230 solid state
computer.
computer.
or primary M.2 2230 solid state
drive.
drive.
Removing and installing components 61