Steps
1. Place the speakers on the system chassis.
2. Replace the two (M2x3.5) and two (M2.5x6, T8) epoxy screws to secure the speakers to the system chassis.
3. Route the cable using the routing channel and connect the speaker cable to the connector on the left I/O board.
Next steps
1. Install the
LED
board.
2. Install the
base
cover.
3. Install the
primary M.2 2280 solid state drive
4. Install the battery.
5. Follow the procedure in
58
Removing and installing components
or
primary M.2 2230 solid state
after working inside your
computer.
drive.