System-board shield
Removing the system-board shield
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
NOTE:
The etchings on the system-board shield do not represent the components that are supported by this computer.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the removal
procedure.
Figure 26. Removing the system-board shield
Steps
1. Remove the four screws (M3x5) that secure the system-board shield to the display-assembly base.
2. Lift the system-board shield off the display-assembly base.
Installing the system-board shield
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
50
Removing and installing Customer Replaceable Units (CRUs)
Before working inside your
computer.