4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.2 Removing the packaging
from the actuator
Note
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the electric
actuator.
2. Check scope of delivery (see Fig. 4-1).
3. Dispose and recycle the packaging in ac-
cordance with the local regulations.
1x
Type 5827-xxx Electric Actuator
1x
Document IP 5827-2
(Important Product Information)
Fig. 4-1: Scope of delivery
EB 5827-2 EN
Shipment and on-site transport
4.3 Transporting the actuator
− Protect the electric actuator against exter-
nal influences (e.g. impact).
− Protect the electric actuator against mois-
ture and dirt.
− Observe the permissible transportation
temperature of –20 to +70 °C.
4.4 Lifting the actuator
Due to the low service weight, lifting equip-
ment is not required to lift the electric actua-
tor.
4.5 Storing the actuator
NOTICE
!
Risk of electric actuator damage due to im-
proper storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions or longer storage
times.
Note
We recommend regularly checking the
electric actuator and the prevailing storage
conditions during long storage periods.
4-1