Connection To The Electronics Box Ctr6000 - Leica DMI6000 B Operating Manual

Note:
The CTR6000 electronics box must not be used
with other stands. The serial number of the associ-
ated stand has been recorded on the back of the
electronics box.
• Connect the Microscope (77.6) socket to the
back of the stand (78.5) using the 25-pin
microscope cable.
• Connect the SmartMove remote control module
to the XYZ-Control socket (77.5).
Fig. 77 Rear view of Leica CTR6000
1 AC power socket
2 XY Stage socket for motorized stage
3 Direct interface socket optional
4 Z Control for separate focus control
5 XYZ Control for SmartMove
6 Microscope socket for microscope
7 12V, max 100W for the lamp power cable of stand
8 DL: reset button
8
5
4
3
2
1
• Connect the motorized stage, if present, to the
XY-Stage socket (77.2).
• Connect the lamp power cable (78.7) to the 12V,
max 100W socket (77.7).
Make sure that the plugs are correctly in-
serted and secured to prevent overheating
of the sockets.
Fig. 78 Rear view of stand
1 RS232 ports
2 2 x USB
3 4 x EXT.
4 XYZ control for SmartMove
5 Connection for Leica CTR6000 electronics box
6 Condenser cable
7 Lamp power cable
6
1
2
7
Caution!
3
6. Assembly
7
6
5
4
53