Exploranium KT-9 User Manual page 37

3 Press the R
IGHT
you accidently pass it, you will have to cycle all the way
around to the value again.
4 Press the L
EFT
5 Press the L
EFT
and get back to the measurement mode.
Taking the reading
Please refer also to the flowchart shown in Figure 5 on page 20.
C
ORE
button to toggle to the desired diameter. If
d: 4
button to set the diameter.
button again to pass through the C: menu
1 You are ready to take a reading, if your
display shows either:
r:C x
This example is illustrated with the
KT-9 set for the L
2 Press the L
button to zero the instru-
EFT
ment while holding it at least 30 cm away
from any magnetically susceptible mate-
rial. The KT-9 will beep when the button
is pressed.
3 The display will show:
If the value is not 0, then you have old
data in memory that should be cleared.
Please refer to "Clearing the memory"
on page 37 for further instructions.
mode
L:C x
or
button.
EFT
C: 0
29