Selecting Mode Of Operation - Exploranium KT-9 User Manual

16

Selecting mode of operation

Selecting mode of operation
1 The display in the measurement mode will have a l: as the
first character, e.g.
2 Press the R
IGHT
also refer to Figure 4 on page 14 to see the flow of events.
3 Press the L
EFT
mode. You should now see the following display:
4 Press the R
IGHT
ment mode.
The mode of operation can only be changed when the data
memory is empty. See "Clearing the memory" on page 37
for details on how to clear the memory.
The KT-9 has four modes of operation:
– In this mode, measurements are activated by the special
P
IN
pin located at the top of the KT-9. This permits easier operation
and achieves much higher accuracy when used for samples with
irregular surfaces. This unique simple mode of operation auto-
matically finds the zero-reference level after the reading has
been taken. Please refer to "P
detailed description on the use of this mode.
L: nP
button twice to get to the C: menu. Please
button once to toggle to the right-handed
C: rH
button again to get back to the measure-
mode" on page 21 for a
IN