Table of Contents
Advertisement
18
Selecting mode of operation
4 Press the L
EFT
displayed, e.g.
5 Press the R
IGHT
6 Press the L
EFT
you will be presented with the d: menu for core diameter
selection. You will have to use the R
to the desired diameter.
7 Press the L
EFT
ment mode. You will pass through the C: menu in this step.
To select Scan mode
The scan mode can only be activated when the KT-9 is set to the
or C
modes, i.e. the display should show either of the
N
-P
O
IN
ORE
following when in right-handed mode:
1 Press the R
IGHT
empty. If the display does not show C: 0, then you will
have to clear the data memory as described in page 37.
2 The display should now show:
3 Press the L
EFT
head should be kept at least 30 cm from any metallic objects
at this point to ensure a proper zero or free-air reading.
button until the A: (
A: nP
button to toggle to the desired mode, e.g.
A:Cor
button. If you have selected the C
button two times to get back to measure-
r: nP
button to check if the data memory is
C: 0
button, while C: 0 is still displayed. The sensor
) menu is
ACCESS
mode,
ORE
button to toggle
IGHT
r:C x
Advertisement
Table of Contents
Need help?
Do you have a question about the KT-9 and is the answer not in the manual?